Handheld automatic screw machine is also called automatic lock screw machine, automatic lock screw machine, automatic screw machine, automatic screw machine, screw lock robot, etc., handheld is required manual operation. Compared with the lock screw method of holding a screw in one hand and an electric batch in the other, the automatic lock screw machine can free one hand to come out, and only need one hand to align the screw hole lock screw.

Merit

1. Screw range: M2-M5.

2. The screw head pattern used is: one word, cross, triangle, plum blossom, hexagon, H head, etc.

3. Screw materials used: iron, copper, stainless steel, etc.

4. Materials of screw products: plastic, iron, aluminum, etc.

5. The locking rate can reach 0.5 seconds 1 screw.

6. The left hand does not need to take the screw, which can be used to hold the product; And it can maintain vertical locking to ensure the quality of locking.

7. No longer directly contact the screws to avoid secondary pollution and rust caused by hand contact.

Notes

1. It is forbidden to put things other than the product into the equipment when using;

2. Pay attention to the tip of the soldering iron to avoid burns;

3. When overhauling the machine, cut off the power supply to prevent electric shock or short circuit;

4. Be careful not to damage and lubricate the track and force the clamp;

5. If you rest or do not work for a long time, please turn off the power;

6. When the electric batch reaches the torque, it will automatically send a screw to the clamp, and after the lock screw locking torque reaches or before releasing the start switch button, the electric batch needs to be raised at some angles to prevent the electric batch cylinder from falling and damaging the clamp and the product, and the clamp cannot be directly dropped to the ground.